chemdesign
Chemical
I am aware of a general design guideline to limit the velocity of rich amine in carbon steel piping to 3 fps. Does anyone have an opinion on the max. allowable velocity in 316SS tubes in the rich/lean exchanger? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Amine Velocity in Stainless Exchagner Tubes
- Thread starter chemdesign
- Start date
- Status
hello,
usually in the design of heat exchanger the velocity is the result of delta P allowable, errosin can limit the velocity, also low velocity reduces heat transfer coefficient.
3 fps is rather a low velocity in heat exchangers tubes.
regards,
roker
usually in the design of heat exchanger the velocity is the result of delta P allowable, errosin can limit the velocity, also low velocity reduces heat transfer coefficient.
3 fps is rather a low velocity in heat exchangers tubes.
regards,
roker
- Status
Similar threads
