Does ENSYS 3015AJ open programs made for FO4020NT. The drawings for the same are not being generated in ENSYS 3i controller when opened via SDD. It opens perfectly fine in F04020 via SDD. But when the same program is opened in ENSYS via SDD(connected to the same server as FO4020NT), it fails to generate the drawing. Is it because the length and breadth of ENSYS being smaller as compared to FO4020?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
AMADA ENSYS
- Thread starter lightl
- Start date
LaserEngine
Industrial
I would say no.
Probably also different G-code etc.
Probably also different G-code etc.
- Thread starter
- #3
- Thread starter
- #4
- Status
Similar threads