Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Alodine/Chem Film Defect 2

Status
Not open for further replies.

Peter the Engineer

Mechanical
May 7, 2021
4
US
Hello,

I recently received multiple parts with the same kind of defect after being treated with chem film and anodizing. I took a picture of it (please see below).
IMG_7095_foxkm9.jpg


I am wondering what might have caused this "bleeding". This had also happened in the past, but the company doing the plating (chem film + anodizing) was never very clear on why this happened. Could anyone please offer a clue? The bleeding does not seem to cause any dimensional variation, but I am really bothered by the appearance of the part. I tried looking for explanations online but could not find anything.

Thank you.
 
Replies continue below

Recommended for you

The oxide film was not removed... and/or the surface area was not cleaned to 'bare aluminum'.

An old mechanic explained this. "When applying chromate conversion coating [CCC, alodine] onto aluminum, if it beads-up and runs-off and doesn't form an adherent colored film... the surface simply isn't clean enough for the CCC to bond with the aluminum molecules.

Regards, Wil Taylor
o Trust - But Verify!
o We believe to be true what we prefer to be true. [Unknown]
o For those who believe, no proof is required; for those who cannot believe, no proof is possible. [variation,Stuart Chase]
o Unfortunately, in science what You 'believe' is irrelevant. ["Orion", Homebuiltairplanes.com forum]
 
Oxide on aluminum grows pretty fast, too.

Any aluminum oxide that's been formed in high temperatures with oxygen can even resist chemical etches; we once has a part that required reactive ion etching to clear out contact vias on a chip

TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
 
Thanks Everyone!

Etching the oxides could be a tricky balancing act between making sure all the oxides are gone and making sure dimensional change is kept at minimum.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top