Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Alloy Selection for Boiling 10% wt. NaOH with Sulfides

Status
Not open for further replies.
chemdesign

chemdesign

Chemical
Joined
May 13, 2004
Messages
22
Location
US
Does anyone have any experience with alloy selection for a boiling 10% wt. NaOH containing 3% Na2S? Temp. is 250 F and pressure is 10 psig. Normally we would use Monel for this application but are concerned with sulfides. Also considering Inconel 600 and Duplex SS (Alloy 2205). Thanks.
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

mrmalcolm
  • Locked
  • Question Question
Selection of stainless steel for direct contact with seawater
Replies
5
Views
3K
EdStainless
EdStainless
rscosta1976
  • Locked
  • Question Question
Alloy 825 behavior under gas production environments
Replies
11
Views
2K
ShabsRBI
ShabsRBI
KPKengineer
  • Locked
  • Question Question
Material Selection for Pumping High Chloride Content
Replies
7
Views
1K
KPKengineer
KPKengineer
SETXINSP
  • Locked
  • Question Question
Conc Sulf Acid Damage to Alloy 20??
Replies
16
Views
1K
SETXINSP
SETXINSP
rmain
  • Locked
  • Question Question
Surface oxidation on Aluminum Alloy & electrical continuity
Replies
8
Views
1K
Gr8blu
Gr8blu

Part and Inventory Search

Sponsor

Back
Top