Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Alloy Selection for Boiling 10% wt. NaOH with Sulfides

Status
Not open for further replies.
chemdesign

chemdesign

Chemical
May 13, 2004
22
Does anyone have any experience with alloy selection for a boiling 10% wt. NaOH containing 3% Na2S? Temp. is 250 F and pressure is 10 psig. Normally we would use Monel for this application but are concerned with sulfides. Also considering Inconel 600 and Duplex SS (Alloy 2205). Thanks.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

mrmalcolm
  • Locked
  • Question
Selection of stainless steel for direct contact with seawater 1
Replies
5
Views
2K
EdStainless
EdStainless
rscosta1976
  • Locked
  • Question
Alloy 825 behavior under gas production environments
Replies
11
Views
2K
ShabsRBI
ShabsRBI
KPKengineer
  • Locked
  • Question
Material Selection for Pumping High Chloride Content
Replies
7
Views
744
KPKengineer
KPKengineer
SETXINSP
  • Locked
  • Question
Conc Sulf Acid Damage to Alloy 20?? 3
Replies
16
Views
760
SETXINSP
SETXINSP
rmain
  • Locked
  • Question
Surface oxidation on Aluminum Alloy & electrical continuity
Replies
8
Views
879
Gr8blu
Gr8blu

Part and Inventory Search

Sponsor

Back
Top Bottom