hookie1985
Industrial
Does anyone have a picture of the alignment tool used to align the safety fence beams?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
alignment tool
- Thread starter hookie1985
- Start date
- Status
Could you maybe elaborate just even a little bit more?
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
LaserSpyder
Materials
any laser can be used to align safety curtain, we used a laser level before getting the actual tool, just have someone with a steady hand hold laser level at first safety curtain where the curtains invisible laser starts (start with bottom mirrors), then make sure you're hitting the second mirror then adjust to where your hitting the third mirror and finally the fourth, repeat with the second set of mirrors on the top, its a little tricky but very doable ![[deejay]](/data/assets/smilies/deejay.gif "[deejay] [deejay]")
I just put my head in front of the emitter and look through the mirrors and make sure I can see the receiver. when I have it working I adjust the emitter all directions until the signal is lost and once I define the boundaries I put it in the middle
Chris Krug Maximum Up-time, Minimum BS
Chris Krug Maximum Up-time, Minimum BS
- Thread starter
- #6
hookie1985
Industrial
thanks guys, i think our reflectors are screwed. someone hit them and they cracked
LaserSpyder
Materials
the mirrors should be an easy fix "bandaid fix It" with any small mirror but if ur talking about the emitter yeah you might have to replace it ![[cook]](/data/assets/smilies/cook.gif "[cook] [cook]")
- Thread starter
- #8
hookie1985
Industrial
i currently have the wires jumped to get by time being. i put the mirrors directly in front of the emitters and taped them on and it still wouldnt reset
That assumes that the emitters and detectors are in the container, doesn't it?
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
LaserSpyder
Materials
IRstuff why are you giving all these links to materials that don't help?? you getting board over there?![[pc]](/data/assets/smilies/pc.gif "[pc] [pc]")
?? Are you referring to my signature block?
Unlike you, there are lots of posters that apparently haven't gotten sufficiently enlightened about the forum policies and the number of forums this site hosts.
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
Unlike you, there are lots of posters that apparently haven't gotten sufficiently enlightened about the forum policies and the number of forums this site hosts.
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert! faq731-376 forum1529 Entire Forum list
- Status