Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
AISI to ASTM?
- Thread starter jthblues
- Start date
- Thread starter
- #3
It is for a 1" BAR so I'm pretty sure the ASTM equiv will be ASTM: 108, 29, 311 or 576...the AISI "spec" seem general and not sure if the need is for hot or cold finished.
The use is for a special NUT that accepts a steel stud to hold motorcycle handlebars to the fram. This NUT is welded into the handlebar ends and the handlebars are ASTM 513 type II steel
The use is for a special NUT that accepts a steel stud to hold motorcycle handlebars to the fram. This NUT is welded into the handlebar ends and the handlebars are ASTM 513 type II steel
- Status
Similar threads
- Locked
- Question
- Locked
- Locked
- Question
