Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Air compressor Tank
- Thread starter godel123
- Start date
The size (and even the existence) of an air receiver is absolutely application dependent. In some applications, it is better to have a very small or no receiver than to have a big receiver. In other applications a big receiver is mandatory.
Share some details and people here might be able to help guide you to an appropriate air receiver.
David
Share some details and people here might be able to help guide you to an appropriate air receiver.
David
An air receiver is essential to every compressed air system to act as a buffer and a storage medium between the compressor and the consumption system.
The Engineering Toolbox has sizing information.
The Engineering Toolbox has sizing information.
"Every" is a really tough concept for me.
I had an application once that needed to slowly ramp pressure from the low setpoint to the high setpoint. Working with the compressor manufacturer and several control valve manufacturers we all determined that the best way to do it was to not have an air receiver and let the compressor build pressure to match increasing resistance--worked great, and the control's solution with a receiver was going to require a PLC and a bunch of custom programming. I admit that this was a really odd situation that hasn't been repeated in 30 years, but it was a real requirement.
Engineers need to keep an open mind for simple solutions that step outside the box a bit.
David
I had an application once that needed to slowly ramp pressure from the low setpoint to the high setpoint. Working with the compressor manufacturer and several control valve manufacturers we all determined that the best way to do it was to not have an air receiver and let the compressor build pressure to match increasing resistance--worked great, and the control's solution with a receiver was going to require a PLC and a bunch of custom programming. I admit that this was a really odd situation that hasn't been repeated in 30 years, but it was a real requirement.
Engineers need to keep an open mind for simple solutions that step outside the box a bit.
David
All,
I think "every" means "often".
It is recommendable to has an air receiver is essential to every compressed air system to act as a buffer.
Control valve will do continuing compressor running loosing energy. If power compressor is high, you will loose a lot of money with control valve.
I hope this helps.
I think "every" means "often".
It is recommendable to has an air receiver is essential to every compressed air system to act as a buffer.
Control valve will do continuing compressor running loosing energy. If power compressor is high, you will loose a lot of money with control valve.
I hope this helps.
Bimr's link is a good place to start Godel23.
Think about how much variation you can accept in your system's air pressure when deciding on an accumulator rather than just going with a 'rule of thumb'. The rule of thumb may be adequate for your system or it could be oversized or undersized. An oversized accumulator may just cost you money but an undersized accumulator may prevent your air system from operating as required.
Think about how much variation you can accept in your system's air pressure when deciding on an accumulator rather than just going with a 'rule of thumb'. The rule of thumb may be adequate for your system or it could be oversized or undersized. An oversized accumulator may just cost you money but an undersized accumulator may prevent your air system from operating as required.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question