Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
AES type HEx
- Thread starter nikimum
- Start date
Sir:
The only place in TEMA that I may provide a partial answer to your question is on Fig. F-3. You can see that the tolerance of the outside diameter floating head cover’s flange is +1/4” –1/8”. There is no tolerance for the inside diameter of the shell’s rear cover. Thus I can’t see the TEMA’s suggestion for that clearance. On RCB-5.22 and Fig. RCB-5.22 you may find the information for packing boxes, but I don’t think that what you are looking for. I would suggest you to submit this question in the TEMA web page:
The only place in TEMA that I may provide a partial answer to your question is on Fig. F-3. You can see that the tolerance of the outside diameter floating head cover’s flange is +1/4” –1/8”. There is no tolerance for the inside diameter of the shell’s rear cover. Thus I can’t see the TEMA’s suggestion for that clearance. On RCB-5.22 and Fig. RCB-5.22 you may find the information for packing boxes, but I don’t think that what you are looking for. I would suggest you to submit this question in the TEMA web page:
- Status
Similar threads
- Locked
- Question
- Locked
- Solved
- Locked
- Question
- Locked
- Question