Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Advanced simulation / Results / Annotation

Status
Not open for further replies.
HonzaS

HonzaS

Mechanical
Nov 5, 2010
21
Hello,

please do you know if it is possible to adjust accuracy (number of digits shown behind decimal point) in the NX postprocessing annotations?

Thanks a lot!
Honza
 
Status
Not open for further replies.

Similar threads

H
  • Question
NX Flow: Results generator error for Tecplot results
Replies
0
Views
2K
Herwig
H
Maxxoru
  • Locked
  • Question
Pin list Annotation
Replies
0
Views
231
Maxxoru
Maxxoru
turbineer
  • Locked
  • Question
SOLVED, NX2206: where's a simple FEA simulation ? 2
Replies
7
Views
927
3DDave
3DDave
Jennifer.S
  • Locked
  • Question
Advanced Weight Management Export to Excel
Replies
0
Views
169
Jennifer.S
Jennifer.S
Bobby4241
  • Locked
  • Question
NX Modal analysis results
Replies
0
Views
141
Bobby4241
Bobby4241

Part and Inventory Search

Sponsor

Back
Top Bottom