Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Advanced simulation / Results / Annotation

Status
Not open for further replies.

HonzaS

Mechanical
Joined
Nov 5, 2010
Messages
21
Location
CZ
Hello,

please do you know if it is possible to adjust accuracy (number of digits shown behind decimal point) in the NX postprocessing annotations?

Thanks a lot!
Honza
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top