additions in dimensions value is not accepting 1

[reswam]

Dear all
If I want to change the dimension by editing in sketch it is not accepting.I mean if I want to increase or decrese the value of 2.1345345 by .5 in this way
2.134534+.5
it is not accepting.I hope for this some where any setting has to change.If any one knows please let me know
Thanks and Regards
Reswam

 

[SBaugh]

The problem is in your VBA. it sounds like it wasn't installed correctly.

If your using SW03 Follow below

Try this for reinstalling the VBA in SW03:

Windows Installer:
Uninstall and reisntall SW per FAQ559-488

Traditional or Install shield:
1) Go to SW install folder on your Hard drive
2) Go to VBA Folder and RMB the vba6.msi and click uninstall
3) Go to CD 1 sw\vba\vba6.msi and install that file.

If your using SW04 then you will have to reinstall.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
When in doubt, always check the help

 

[reswam]

Thank you Sbaugh