Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Adding symbols 2

Status
Not open for further replies.
Mirrorman44

Mirrorman44

Automotive
Nov 11, 2008
16
Looking to add "less than equal to" symbol to drawing notes
is there an easy way to add without creating them with lines?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
If the above doesn't work you may have to try an alternative font. Some of the fonts don't support the extra characters.

Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Werner K
  • Locked
  • Question
Pull expression values into a component when adding to an assembly
Replies
5
Views
615
Werner K
Werner K
imti7
  • Locked
  • Question
Is it not possible to add Full triangle(uni, double,triple) surface finish symbols in NX cad? 2
Replies
8
Views
559
imti7
imti7
Befuddled
  • Locked
  • Question
P & ID symbols
Replies
1
Views
265
jerry1423
jerry1423
M
  • Locked
  • Question
Adding parent to non-timestamp geometry objects.
Replies
14
Views
567
Toost
Toost
AndySimulation
  • Locked
  • Question
Adding points on a SketchIntersectionCurve
Replies
0
Views
76
AndySimulation
AndySimulation

Part and Inventory Search

Sponsor

Back
Top Bottom