Adding inspection numbers to dimensions

[GRF]

This topic was covered in the past and the posting has been closed,

http://www.eng-tips.com/viewthread.cfm?qid=205851.

However, the macro posted by Handleman, a macro guru, will not work in SW2009. I have tried this on two computers and get the same results on both, Compile error: Can't find project or library, with Sub AddDimRefNems() highlighted yellow.

Since I know about as much about writing macros as I do about the dust on Pluto any help would be appreciated.

 

[handleman]

You may have to fix references to make it work after upgrading to 2009, but the code still works. Edit the macro and go to Tools->References in the VBA editor. Un-check any missing 2008 (or earlier) references and find their corresponding SW 2009 version.

Alternately, if you are pasting the code into a new macro, make sure it is a VBA macro and not a VSTA macro.

-handleman, CSWP (The new, easy test)