I'm working on a design with a face gear of European origin which references an addendum coefficient and a dedendum coefficient. What happens to the face gear when these coefficients are less than 1.0 or greater than 1.0? Is there a resource that explains this in detail?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Addendum & Dedendum Coefficients Face Gears
- Thread starter badpeanut
- Start date
badpeanut,
It's not an ISO or DIN reference, but AGMA 203.02 and 203.03 discuss face gear geometries with a 20deg press angle spur pinion.
Chapter 18 of Litvin's book "Gear Geometry and Applied Theory" also gives a very detailed description of face gear geometries.
Hope that helps.
Terry
It's not an ISO or DIN reference, but AGMA 203.02 and 203.03 discuss face gear geometries with a 20deg press angle spur pinion.
Chapter 18 of Litvin's book "Gear Geometry and Applied Theory" also gives a very detailed description of face gear geometries.
Hope that helps.
Terry
- Status
Similar threads
- Locked
- Question
- Question