Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Active filter

Status
Not open for further replies.
hekimoglu

hekimoglu

Electrical
Joined
Aug 19, 2003
Messages
6
Location
TR
I would like the learn exact frequency range for tweeter, woofer and normal speaker.
I shall use these values in active filters for a music system design. I wanna seperate the amplifiers output signal into these three parts.


Thanks...
 
Sort by date Sort by votes
It depends on the drive units that you use.

The manufacturer of the drive unit should supply data sheets describing the frequency range.

rgds
Zeit.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

sunny2021
  • Locked
  • Question Question
The output interference of the voltage sensor is large, how to choose the filter
Replies
3
Views
475
hacksaw
hacksaw
SolarTrap
  • Locked
  • Question Question
How is the power via USB filtered in an Arduino Nano
Replies
5
Views
408
MacGyverS2000
MacGyverS2000
Jieve
  • Locked
  • Question Question
Need help with RF CM-Filter Design Problem
Replies
5
Views
452
Jieve
Jieve
juancervi
  • Locked
  • Question Question
MATLAB - Troubles filtering very noisy signals using narrow pass band filter
Replies
6
Views
395
snarkysparky
snarkysparky
CarlNorman1981
  • Locked
  • Question Question
16 bit PCM bus - Notch filter / Tone detection
Replies
8
Views
471
CarlNorman1981
CarlNorman1981

Part and Inventory Search

Sponsor

Back
Top