Hey,
i'm coming from ABAQUS and im new to ANSYS, so i still lack some fundamentals. I am currently using the ACP and static mechanical modules to simulate a tensile Test of a Basic UD layer. In ACP Post after defining the failure criterion, ANSYS shows me where Elements have failed due to which criterion. Now i was wondering if i can also see when the first failure occured. I basically want to see the results of the analysis between 0% and 100% and see, if and when failure occurs.
Im also glad about any ACP related postprocessing guides/literature.
Thank you in advance!
i'm coming from ABAQUS and im new to ANSYS, so i still lack some fundamentals. I am currently using the ACP and static mechanical modules to simulate a tensile Test of a Basic UD layer. In ACP Post after defining the failure criterion, ANSYS shows me where Elements have failed due to which criterion. Now i was wondering if i can also see when the first failure occured. I basically want to see the results of the analysis between 0% and 100% and see, if and when failure occurs.
Im also glad about any ACP related postprocessing guides/literature.
Thank you in advance!