Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ACME THREADS
- Thread starter jheal
- Start date
MartinBellehumeur
Industrial
I'm not sure if it's available in the hole command (I'm assuming you've already looked), but I would suppose one way of doing it would be to use the Worm Gear Designer... or a helical cutout with a 29 degree slope, patterned in a circle.
Hope this helps,
Martin
Hope this helps,
Martin
beachcomber
Mechanical
You can add the thread details to the Holes.txt file, then you will be able to select it as for other threads
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
- Status