Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Accurate plotters

Status
Not open for further replies.
trithis

trithis

Aerospace
Jul 17, 2003
8
We have a plotter that is accurate but getting old and getting hard to find parts for. We have sent many files out for test plots by the plotter vendors but most were not accurate enough. Has any one found a 36" or 48" wide plotter that they like and that works well from a roll on .020 thick mylar, if so please let me know before ours dies.

Larry
 
Replies continue below

Recommended for you

Sort by date Sort by votes
My HP 488CA Designjet prints 36" wide, and I find that its factory settings make its plots accurate to 1/16" in 6 feet. It has an option to calibrate, but since it's good enough for me, I haven't played with it. Not sure if HP still makes the 488...

STF
 
Upvote 0 Downvote
We have an HP DesignJet 800, and it works great. One thing to keep in mind though. Before any high quality mylars are plotted, you MUST calibrate the plotter prior to plotting the mylar.

Dennis

 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom