Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

acceptance criteria for visual inspection in ASME Code Sec IX Ed.2019

Status
Not open for further replies.
JR 166

JR 166

Mechanical
Joined
Jan 27, 2019
Messages
5
Location
PE
In Which part of ASME IX Ed.2019 can you find the acceptance criteria for visual inspection of welders qualification.
I need to know the acceptance criteria for refoircement, undercut, etc

Thank you for your answers...
 
Sort by date Sort by votes
Article I has the acceptance criteria if I remember correctly. However, Section IX is very sparse on visual criteria. There are no visual criteria for overlap, undercut, reinforcement, porosity. etc.

Best regards - Al
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

timsch
  • Question Question
Question of scope of ASME BPVC SECTION IX
Replies
1
Views
9K
DekDee
DekDee
FAHADRANA
  • Locked
  • Question Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee
Motivated Apprentice
  • Locked
  • Question Question
Diameter in ASME IX
Replies
2
Views
1K
Motivated Apprentice
Motivated Apprentice
victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
13K
victor6397
victor6397
MhmdNfri
  • Question Question
ASME Sec. I / NDT / PW-11 / Table PW-11
Replies
2
Views
484
goutam_freelance
goutam_freelance

Part and Inventory Search

Sponsor

Back
Top