Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

About Wind Load

Status
Not open for further replies.

Panther3157

Structural
Jun 15, 2012
3
CA
Hi Joshplum,

Good morning. I don't have a Risa Floor. Just have Risa 3D. When calculating the steel structure, just respectively put the wind area load x and wind area load Z along the surface of the structure, then combine the wind load with other loads to do design check, is that ok?

Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top