NguyenNhat
Civil/Environmental
Hi everyone, someone please tell me what code require that we must design the standby filter in the circulation system for public swimming pool? thank you very much, and sorry about my bad English.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
About standby filter in circulation system for swimming pool
- Thread starter NguyenNhat
- Start date
- Status
I am not sure exactly what information you are looking for but here are some typical design parameters for the filters that may get you started.
You should be able to recirculate the whole contents of the pool through the filters in 4 hours or less.
Filtration rate is typically 20-40m/hr for a multimedia filter.
It is usual to use multiple cells so that the circulation pump has enough flow capacity to backwash one of the cells with the others off line.
Regards
Ashtree
"Any water can be made potable if you filter it through enough money"
You should be able to recirculate the whole contents of the pool through the filters in 4 hours or less.
Filtration rate is typically 20-40m/hr for a multimedia filter.
It is usual to use multiple cells so that the circulation pump has enough flow capacity to backwash one of the cells with the others off line.
Regards
Ashtree
"Any water can be made potable if you filter it through enough money"
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question