Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

about offset command in ANSYS

Status
Not open for further replies.
sachin46

sachin46

Marine/Ocean
Jun 12, 2013
33
thread569-263934
With refrence to above thread can anybody help me o know offset command for splines ,curves ?
Regards,
SACHIN
 
Status
Not open for further replies.

Similar threads

O
  • Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
AndrewSkocz
  • Locked
  • Question
Ansys - Solving an input file using command line
Replies
3
Views
883
NRP99
NRP99
X
  • Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
950
xinyu3liu
X
S
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
R
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
674
Rabea-19
R

Part and Inventory Search

Sponsor

Back
Top Bottom