Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

About 3in1 filler in Cooling Tower

Status
Not open for further replies.
GOLFF

GOLFF

Mechanical
Sep 23, 2007
3
I will design 3in1 filler(combine of Louver,filler and eliminator) in cooling tower. but I don't know why the angle of connecting between filler and louver is 45 degree.(I see from the old one)
It is the global design? or 45 degree is the best in engineering design?

Could I get further information or source of filler design

Thank you

 
Replies continue below

Recommended for you

Sort by date Sort by votes
It sounds like you are describing a wet cooling tower. Are you designing one? Why not simply buy a manufactured unit?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

crshears
  • Question
Question About Escape of Pressurized Hot Water
Replies
1
Views
123
goutam_freelance
goutam_freelance
POPPASMURFF1942
  • Locked
  • Question
Cooling Tower Packing 2
Replies
4
Views
352
pierreick
pierreick
Al_eng
  • Locked
  • Question
Cooling Tank Sizing 5
2
Replies
31
Views
2K
georgeverghese
georgeverghese
PersonalProfile
  • Locked
  • Question
Power Station Cooling Capacity More in United Kingdom, than Australia, Despite Apparent Weather Advantage, Justification Request
Replies
5
Views
2K
goutam_freelance
goutam_freelance
mechE17
  • Locked
  • Question
VFD Enclosure Passive Cooling 1
Replies
15
Views
834
IRstuff
IRstuff

Part and Inventory Search

Sponsor

Back
Top Bottom