Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Abaqus subroutines; Are COORDS and TEMP(1) for node point or integration point

Status
Not open for further replies.
GustavLund

GustavLund

Mechanical
Joined
Jan 26, 2011
Messages
10
Location
SE
I'm using the subroutines HETVAL and USDFLD in Abaqus. In USDFLD, COORD is being an input. Is this the coordinates for the current integration point or the current node? And the same question for the TEMP(1) in HETVAL.

I'm not calling any other routines.

I have looked in the manual but I'm still not sure. Does anyone know? Thanks!
 
Status
Not open for further replies.

Similar threads

mj345
  • Locked
  • Question Question
Importing point co ordinates in ABAQUS
Replies
1
Views
2K
FEA way
FEA way
F
  • Question Question
ABAQUS error - 'Node set assembly_left_rp' has not been defined
Replies
1
Views
3K
Vishakh_Rajendran
Vishakh_Rajendran
S
  • Question Question
Stress values are more compared to experimental results and cracks are not formed on concrete for DOUBLE PUNCH TEST simulation in abaqus software
Replies
7
Views
5K
Shreyas M
S
B
  • Locked
  • Question Question
Concentrated Force on a Rigid body reference point
Replies
2
Views
3K
Vishakh_Rajendran
Vishakh_Rajendran
nilesh_dot
  • Locked
  • Question Question
Problem during linking - Abaqus/Standard User Subroutines
Replies
2
Views
1K
nilesh_dot
nilesh_dot

Part and Inventory Search

Sponsor

Back
Top