Lukas Smith
Student
Hello all,
I am currently doing a simulation from Abaqus using the subroutine VUAMP.
I have returned the return values as amplitude via a boundary condition and the return works.
Before I implemented the return, the body rotated through a contact condition and there was a sensor attached to it.
However, by returning the subroutine, I would like to affect the body only under certain conditions.
So my question is, is there a way to say: if.. return no value and don't influence the body..else ... return amplitude....
Thanks a lot for your help!
I am currently doing a simulation from Abaqus using the subroutine VUAMP.
I have returned the return values as amplitude via a boundary condition and the return works.
Before I implemented the return, the body rotated through a contact condition and there was a sensor attached to it.
However, by returning the subroutine, I would like to affect the body only under certain conditions.
So my question is, is there a way to say: if.. return no value and don't influence the body..else ... return amplitude....
Thanks a lot for your help!
