ABAQUS FEM-Simulation

[PascalKruse]

Hey guys,
I have a problem towards my Abaqus-Modell. When limiting my max inkrement of the interesting step to 0.01 in order to gain more steps and therefore more detailed information my solver stops after about 20% of the time. When I reset the max inkrement to 1 the simulation runs without any problems but obviously isnt detailed enough. My msg. File tells me that the solver needed a smaller inkrement than my min inkrement. But when I change the min inkrement the simulation might become too big and too detailed Anyone here that worked with Abaqus and can help? Thank you!!
Best Regards, Pascal from Germany, Aachen

 

[FEA way]

You don't have to change the maximum and minimum increment size to get more or less frames of output. Simply adjust the frequency of this output when creating a request.