ABAQUS: change sketch of Parts afterwards

[J.Realer]

Hallo everyone,

i'm using ABAQus for a FE-Simulation.
Is there a chance to change the sketch or the measures of Parts, without redo the input of the section, the assembly and the constraints?
I did a mistake right at the beginning and wondered if, i can just correct the measures of the Part instead of setting up nearly the whole Model again.

It would be nice if you can help me to save time.

Thanks.

 

[FEA way]

Yes, you can edit part's geometry and features should regenerate (as much as possible for a given level of modification). Give it a try.

 

[J.Realer]

Thanks. it works just like that.