Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

6Al-4V tube bending

Status
Not open for further replies.
gstark

gstark

Aerospace
Joined
May 5, 2003
Messages
14
Location
US
Does anyone have sources of fabricators capable of making swept tube bends in 6-4 Ti ? Bend specifics would be 3/4" to 3" OD tubing, .025" to .040" thickness. Bend radii would be from 1-D to 3-D. Bend angles from 10-90 degrees.
 
Status
Not open for further replies.

Similar threads

C
  • Question Question
How to Air-Seal Oval Tube into Hole!
Replies
5
Views
722
chuwiEngineer
C
swearingen
  • Question Question
Can Standard Flanges Resist Full Bending Strength of Pipe?
Replies
7
Views
3K
swearingen
swearingen
AnisaMaski
  • Locked
  • Question Question
Axial, bending and Torsional Stiffess
Replies
1
Views
434
LittleInch
LittleInch
S
  • Locked
TUBE TO TUBESHEET MOCK UP PROCEDURE FOR HEAT EXCHANGER
Replies
0
Views
716
sameerjoshi1969
S
Ann-123
  • Locked
  • Question Question
Hot sand bending historical methods
Replies
6
Views
449
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top