Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

6Al-4V tube bending

Status
Not open for further replies.
gstark

gstark

Aerospace
May 5, 2003
14
Does anyone have sources of fabricators capable of making swept tube bends in 6-4 Ti ? Bend specifics would be 3/4" to 3" OD tubing, .025" to .040" thickness. Bend radii would be from 1-D to 3-D. Bend angles from 10-90 degrees.
 
Status
Not open for further replies.

Similar threads

C
  • Question
How to Air-Seal Oval Tube into Hole!
Replies
5
Views
330
chuwiEngineer
C
swearingen
  • Question
Can Standard Flanges Resist Full Bending Strength of Pipe?
Replies
7
Views
3K
swearingen
swearingen
AnisaMaski
  • Locked
  • Question
Axial, bending and Torsional Stiffess
Replies
1
Views
330
LittleInch
LittleInch
S
  • Locked
TUBE TO TUBESHEET MOCK UP PROCEDURE FOR HEAT EXCHANGER
Replies
0
Views
638
sameerjoshi1969
S
Ann-123
  • Locked
  • Question
Hot sand bending historical methods
Replies
6
Views
304
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top Bottom