Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

5-axis CNC where A & B axis are not intersecting?

Status
Not open for further replies.
eatfood

eatfood

Industrial
Sep 7, 2012
13
When programming 5 axis CAM, say using conventional 5 axis machines (X Y Z A B) with a trunion table. If A, B and spindle Z axis are not intersecting, is there normally correction for this in the g-code? Do most CAM assume the axis are intersecting?
 
Status
Not open for further replies.

Similar threads

jsnysny
  • Locked
  • Question
Where to find samples of Lubricants?
Replies
5
Views
1K
3DDave
3DDave
drawoh
  • Locked
  • Question
CNC Programming Left Hand Right Hand
Replies
4
Views
475
3DDave
3DDave
AbdullahE
  • Locked
  • Question
Cnc code
Replies
1
Views
291
enginesrus
enginesrus
T
  • Locked
  • Question
Why use a buildbotics controller
Replies
0
Views
947
thomas29
T
Radius1
  • Locked
  • Question
CNC Op 10 and Op 20
Replies
2
Views
1K
enginesrus
enginesrus

Part and Inventory Search

Sponsor

Back
Top Bottom