Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
42" Field Bending
- Thread starter doyleadr
- Start date
LittleInch
Petroleum
Ask a construction company or pipie bending supplier like CRC evans
This is a little vague and diffiuclt to understand what you're looking for.
Search pipe bending on U tube and you'll find a few of real life bending.
essentially quite simple, Load the pipe in, clamp one end, lift the other end against the shoe, lower pull the pipe in until the bend is just at the end of the shoe and repeat until you get the angle you want.
Looks quite a thin pipe so you will probably need an internal mandrel, but do a test bend and see what happens.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
This is a little vague and diffiuclt to understand what you're looking for.
Search pipe bending on U tube and you'll find a few of real life bending.
essentially quite simple, Load the pipe in, clamp one end, lift the other end against the shoe, lower pull the pipe in until the bend is just at the end of the shoe and repeat until you get the angle you want.
Looks quite a thin pipe so you will probably need an internal mandrel, but do a test bend and see what happens.
Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question