Kuldipkenya
Electrical
- Mar 3, 2008
- 21
I have rewound a 40hp ETM Motor 4POLE 3PHASE. The winding details are as follows--slots48, span 1-10, turns 14 of 3wires, 1/2 slot winding, SWG--17 1/2 X2 + 18X1.
The motor is drawing 35amps on delta on NO LOAD.This is too high. Can i get the original winding details as this motor had been done else where before i got it.
The motor is drawing 35amps on delta on NO LOAD.This is too high. Can i get the original winding details as this motor had been done else where before i got it.