Morning all,
I'm starting to pull my hair out a bit with the 3Dexperience Piping&Tubing workbench. In CATIA V5 I used to rely heavily on the compass to route runs. This was super efficient as I could quickly route a run along the desired path.
In 3Dexperience there doesn't seem to be an option to use the robot (aka compass in V5) to define the route geometry? Has anybody else come across this issue and found a quick way to use the new, in my opinion, super clunky user interface to run and adapt route geometries?
Thanks,
Fabian
I'm starting to pull my hair out a bit with the 3Dexperience Piping&Tubing workbench. In CATIA V5 I used to rely heavily on the compass to route runs. This was super efficient as I could quickly route a run along the desired path.
In 3Dexperience there doesn't seem to be an option to use the robot (aka compass in V5) to define the route geometry? Has anybody else come across this issue and found a quick way to use the new, in my opinion, super clunky user interface to run and adapt route geometries?
Thanks,
Fabian