Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3D Orphan Mesh To Geometry Part

Status
Not open for further replies.

cranisch

Mechanical
Joined
Jan 25, 2007
Messages
25
Location
DE
Hello everybody!
I have got a 3d-orphan imported that I want to transfer into a 3d-geometry part.
I know that there is the possibilty to do it for 2d orphan meshes by using "Part2DGeomFrom2DMesh".

Is there any possiblity to do it for 3d meshes, too?
thx in advance
 
Hi !

Try to export mesh to VMRL format. Then you can import it to CAD system.

Regards
 
I don't think its possible in Abaqus, because orphaning a mesh is like the "Remove Parameters" command in NX6 if you're familear with that. Exporting it as a VRML would kinda work, but you'd still end up with a faceted single body, non-editible I delieve too; at least not in any easy way.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top