360degrees redundant dimension

[mudassirkhan]

Dear friends,


I have made a revolve cut of 360degrees. But i dont want proe to show me the angle 360deg. Actually it is a redundant dimension because if i am making a revolve cut throughout the shaft then why should proe unnecessarily show me 360deg. Any idea how i should get rid of this 360deg angle. Thanks in advance


Regards,

 

[Israr]

I hate this as well. There should be an option not to show it in drawings.


Israr

 

[appinmi]

If you are showing the dimensions for this revolve from a side view, or cross section, in the show/erase window, select dimension in view. Then select the feature in the view you want the dimensions to show up in. Only the dimensions that can be shown in that view will appear. The 360

 

[mudassirkhan]

Thanks for the suggestion but actually as per my checklist there should be no extra dimensions, irrespective of any view.


Regards,

 

[appinmi]

Sometines, this dimension is something other than 360

 

[dr_gallup]

There used to be an option for the revolved cut/protrusion functions where it could be 0, 90, 180, 270, full or variable. The dimension did not show unless it was variable. Somewhere in the WF improvements this was lost.