Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

316 & 316L

Status
Not open for further replies.
azizur447

azizur447

Materials
Joined
Aug 14, 2013
Messages
26
Location
CA
Can anyone tell me is there any difference of average grain size (ASTM El12 Test Methods) for the steel of SA-479 316 & 316L.

Thanks

 
Sort by date Sort by votes
There could be differences (slight to moderate) based on prior thermal/mechanical processing.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mechengineer
  • Locked
  • Question Question
MAP & MAWP
Replies
5
Views
871
mechengineer
mechengineer
MUHAMMAD FAHAD RANA
  • Locked
  • Question Question
WPS/PQR & Filler Wire Selection
Replies
4
Views
992
weldstan
weldstan
Tony39
  • Locked
  • Helpful tip Helpful tip
ASME B31.12 & Mf (performance factor)
Replies
0
Views
522
Tony39
Tony39
KevinNZ
  • Locked
  • Question Question
Design Pressure- MAWP & limit load analysis
Replies
8
Views
708
KevinNZ
KevinNZ
Jaivishnu
  • Locked
  • Question Question
Difference between leak testing (Section ASME V) & hydrotest / pneumatic test ( ASME Section VII
Replies
2
Views
2K
r6155
r6155

Part and Inventory Search

Sponsor

Back
Top