I'm having trouble meshing a 2d geometry with randomly oriented rectangular pieces inside of a matrix material. I get very good meshes when the internal rectangles are aligned, but the mesh always seems to fail with the randomly oriented pieces. Does anyone have any recommendations?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
2D mesh failure with randomly oriented pieces
- Thread starter jsmerson
- Start date
GregLocock
Automotive
Since it is about a hundred years since I used HM I can't remember how but there is basically a one click command to reorient all the element directions. I imagine the help might be of some use.
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376
Cheers
Greg Locock
New here? Try reading these, they might help FAQ731-376
- Status
Similar threads
- Locked
- Question