1008 and 1010

[aerodoc]

What is the yield strength, and tensile strength of 1008 and 1010 steel used for stamped parts in the automotive industry. I am getting confused with cold drawn, bar, hotdrawn, annealed, etc.

Where can I get a stress strain curve values that I can use in ABAQUS?

Thanks

 

[TVP]

The Auto Steel Partnership has quite a bit of good data available on their website.

http://www.a-sp.org/database/pdf/CarsAsdm/Chapter2/section2-04.pdf

http://www.a-sp.org/database/pdf/CarsAsdm/Chapter2/section2-05.pdf

DDS means deep drawing steel, which is produced by cold-rolling then annealing, and has a composition similar to grade 1008 according to SAE J403.