martylosch
Mechanical
I have a requirement to replace existing motors with the following spec: Epoxy coated, 1/12th hp (60 watt), single phase, 115, 2.0 A, 60 Hz, 3000 RPM, TEFC. Any suggestions on where to purchase (or manufactures) - Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
1/12 HP AC Motor
- Thread starter martylosch
- Start date
- Status
electricpete
Electrical
60hz 3000rpm?
Are you sure it isn't either 50hz/3000rpm or 60hz/3600rpm?
Epoxy coated may need some clarification. But I believe some of the manufacturers are using vpi on their random wounds now. (used to be all varnish). Maybe it will be available off-the-shelf as part of a severe-duty IEEE841 option.
Nothing else should be a problem. I would enlist the help of any local distributor to give you options.
Are you sure it isn't either 50hz/3000rpm or 60hz/3600rpm?
Epoxy coated may need some clarification. But I believe some of the manufacturers are using vpi on their random wounds now. (used to be all varnish). Maybe it will be available off-the-shelf as part of a severe-duty IEEE841 option.
Nothing else should be a problem. I would enlist the help of any local distributor to give you options.
electricpete
Electrical
Why do you want to specificallyy identify epoxy? If you are just concerned about resistance to chemical/moisture intrusion, then maybe you should formulate your spec a little differently.
- Status
Similar threads
- Locked
- Question