Search results for query: *

Thank You for pointing it out to me. I am sorry to have wasted your time. Thanks

this is the mixer in question. Thankshttp://files.engineering.com/getfile.aspx?folder=7a624405-874a-45b5-8921-bfb57171235e&file=sp60_lorezcolor.jpg

I have attached the picture.http://www.globeslicers.com/site/products.asp?id=271

This is a commercial unit with a 3hp motor . I want the rpm for the Kneading head. Thanks

I would like to know the speed of a dough mixer. In RPM. this is because i am modifying a machine and will be using pullies . From the motor to the main drive shaft. Thank you

I would like to know the speed of the dough mixer in RPM. ie dough knead . Thanks

I have a 3HP--3phase ABB 24v contactor and a ABB overload relay.I also have a on/off switch, emergency off switch and a timer. There is a transformer with input of 2phase 380v and out put 24v. I want to rewire the whole unit as some one messed it up. Please help.I have the wiring diagram but it...

Thanks everyone. I spoke to the manufacturers and they say the motor is the right size. The stamping for the amps is wrong. It should be perm cap as the starting should not be too powerful .Otherwise the drive chain could snap. Thanks once again.

I have a dough mixer. The motor burnt out. The motor is rated -1.5hp 1400rpm single phase, 220v perm capacitor . The name plate reads 1.6 amps.IP44. I want to replace the motor. Should i use Cap Start Cap Run motor or should i just stick to the original permanent cap motor. This is a large...

I have rewound a 40hp ETM Motor 4POLE 3PHASE. The winding details are as follows--slots48, span 1-10, turns 14 of 3wires, 1/2 slot winding, SWG--17 1/2 X2 + 18X1. The motor is drawing 35amps on delta on NO LOAD.This is too high. Can i get the original winding details as this motor had been done...

Sorry I meant Equalizers connections on the windings this helps in the mech balance and reduces the noise

I would think it is the connections on the windings. Have you tried jumpers on the windings. This can help the uneven air gap for sure.

Thanks ankervik, i will contact Siemens

I have a SIEMANS electric motor and i am looking for the original winding details.The only detail of the motor i have is-30HP 2930RPM 3PHASE SNO. H810, 0458 , 54002. Any help will be appricated

We have just rewound a eight pole motor.The motor is drawing 10amps .It is 5hp 420v delta connected.Now this is above full load.The windings seem to be fine.The original windings had 28 turns per coil. Now we are rewinding it again with 31 turns per coil.What would be the amps now? It has 36...

Thanks every one.Will replace the motor. Thanks

Yes it is TEFC motor. Horizontal mounted.The motor is in air flow.It is used 15hours a day.About the ambient humidity i can only say that it is in a heavy rainfall area.

We have a motor which drives a fan. It is mounted on top of a Tea Dryer.We have a problem that the motor fails after every six to eight months.Every time the windings on the drive end are burnt but the non drive is as good as new. The bearings are ok, so are the bearing housings.The drive belts...

I am looking to build my own curing oven.Where can i get the plan or drawings.I will be using it to cure electric motors. Thanks

Try like this, X Y Z-------Line U V W-------Open SLOW SPEED U V W--------Line X Y Z--------Join Together HIGH SPEED Hope this helps