Yep, exactly what I was suggesting.
As far as the task pane, that's the toolbar options that are typically over on the right. I'll try to attach a screenshot.
Normally there would be more options/windows there than what you have shown in your screenshot. Perhaps the other boxes are there and...
Can you right click on it in the file tree to check it out from there?
Which version of solidworks?
Are there other windows available on the task pane? I see others in addition to the info box.
They look a lot like McMaster 5923K32. These are similar to those used in devices like a "Cool Shirt".
https://coolshirt.com/product-category/motorsports/motorsports-kits/
I've not personally seen any actual drawings etc, but the link below includes some maintenance type information.
http://www.usmed-equip.com/content/datesheet/pdfs/Pulmonetic%20LTV%201200-1150%20Service%20Manual%20Rev%20E.pdf
Matt Smith
Mechanical Engineer
I've updated Draftsight on a couple of machines to the latest and greatest 2017 SP2. The software immediately crashes after activation.
I've tried a clean install and just about everything else I can think of. Any suggestions?
Thanks,
Matt
Matt Smith
Mechanical Engineer
I am searching for information regarding cast steel, stainless steel, & superalloy materials suitable for high temperature (>1000F) applications with higher hot strength. I have found several grades which are of interest A217, A297, A447, A487, & A351. I am looking for a resource(s) which have...
Thank you all for your comments. I recently had the same issue after a fresh install and found this posting again.
Disabling the "smooth scrolling" option in SetPoint Settings did the trick. Game detection was turned off.
Matt Smith
Mechanical Engineer
TheTick - I had never inserted more than one part into a part. Thank you for the suggestion.
ctopher - Once it is an assembly there are some cutting options (wrap in this instance) which I would like to use that are no longer available.
Matt Smith
Mechanical Engineer
Thank you for the suggestions. I have previously used configurations for this type of component. I have several different versions of this part which use the base welded assembly as the starting part. Then through additional welding and/or machining operations it is made into other finished...
I am working on creating an assembly of parts which is machined. What I'm looking for is others experiences to try to determine a best practice for this type of a part. The finished part is created by machining two parts, welding them together, and then finish machining additional features...
I'm having an intermittent problem with my Logitech M705 mouse in Solidworks. I use the center mouse wheel rotation to zoom in and out. Occasionally it will start zooming and not stop when the mouse wheel stops. Has anyone else experienced this? Any suggestions?
I am using the current...
From Hoosier's A6/R6 care and feeding instructions:
http://www.tirerack.com/images/pdf/warranty/HOOSIER.pdf
"Freeze Crack Advisory: This advisory addresses proper storage and use of Hoosier tires in cold conditions. Hoosier Tires, especially asphalt and hard compound
tires, may experience...
Thanks for the responses everyone.
Jeff,
Win 7 x64, SW 2012 x64 SP5.0, ATI FirePro V7800, driver 8.830.5.4000 (SW current approved)
The surface is there and can be selected if you click on it. It just appears clear. BUT if you hover the cursor over the surface, it does not highlight like a...
I've got a part I've created in Solidworks and am having trouble with a surface on the part. It's showing up as clear or transparent. The surface is not set to be transparent nor is the material/appearance set to something which is clear. I've attached the part to the post.
Anybody seen this...
