Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. S

    Material used for the rotating shaft in Flowserve BB2 centrifugal pumps?

    Thank you very much for your response and your help — I really appreciate it! Yes, you're right, if it's an API 610 pump, the shaft material is generally selected according to Table H.2 (I'm also referring to the 10th edition). However, the challenge I'm facing is that determining the material...
  2. S

    Material used for the rotating shaft in Flowserve BB2 centrifugal pumps?

    Hello everyone, I'm currently researching API 610-compliant BB2 centrifugal pumps, specifically those manufactured by Flowserve. I would like to know what material is typically used for the rotating shaft in these pumps. I've reviewed some general documentation, but I couldn’t find precise or...
  3. S

    Request for Help – Shaft Design for BB2 Centrifugal Pump

    Hello everyone, I'm working on the shaft design of a BB2-type centrifugal pump (API 610 compliant) and I'm looking for any technical documents, guides, or references that explain the design process step by step. If you have any relevant materials or can share your experience, I’d really...
  4. S

    Looking for Traditional Method to Design Centrifugal Pump Impeller 🔧

    Hello everyone, I’ve been searching for quite some time for the traditional method of designing a centrifugal pump impeller — the one based on manual hydraulic calculations, not the modern CFD/CFX-based approach that starts with a meridional surface. I’m specifically looking for a method...
  5. S

    Request for documents or assistance on mechanical design of conical shaft section in centrifugal pumps

    Thank you very much for your helpful response and for sharing the link — the information on tapered shaft end design is quite relevant and gives me a clearer understanding of the general design approach. Thanks again for taking the time to support me — I truly appreciate it! Best regards,
  6. S

    Request for documents or assistance on mechanical design of conical shaft section in centrifugal pumps

    Hi Artisi, Thank you for your reply. To clarify what I meant by "conical section," I’ve attached an image of a centrifugal pump where I’ve highlighted the part I'm referring to in yellow. It’s the tapered (conical) section of the rotating shaft located near the impeller, which typically...
  7. S

    Request for documents or assistance on mechanical design of conical shaft section in centrifugal pumps

    Hello everyone, I am currently looking for detailed technical documents or studies on the mechanical dimensioning of the conical section of the rotating shaft in centrifugal pumps. Specifically, I need resources explaining the calculation steps, design criteria, as well as the specifications...
  8. S

    design a centrifugal impeller

    Hello everyone,I’m working on the geometric design of a centrifugal pump impeller and need guidance on drawing its meridional (axial) section. Specifically, I’d like to : Determine the axial extension z_E and the radii of curvature R_DS and R_TS for the front and rear shrouds (see Chap. 7.2.2.1...

Part and Inventory Search

Back
Top