Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ISSAM_20

    Hot Water & Heat Recovery Design

    Hi Immsk, Thank you very much for your feedback. I agree that the purpose is to have a minimum pressure drop betwen the two TEEs, But i think this is true if only we have a straight pipe before TEEs with a a considerable Length, don't you think? But according to the pipe layout shown above...
  2. ISSAM_20

    Hot Water & Heat Recovery Design

    Hi Everyone, I'm working on a hot water plant design but the client instructed us to associate this design with a heat recovery system which is available due to compressor helium cooling. So we did as asked and we link two hydraulic loops directly on the cold line of the main loop, as show in...
  3. ISSAM_20

    Welding defects validation using stress analysis

    Thank you RON for your feedback. You are right.but as i said and client was agree, the type of the defect is 2011 which is means : Gas Pore,A gas cavity of essentially spherical form, according to the Tbale 1, ISO 6520-1. Also since i have lower temperature and pressure ( 80 degre and 6 7 bar)...
  4. ISSAM_20

    Welding defects validation using stress analysis

    Hello Members, I am currently facing an issue concerning the installation of a Hot water and chilled water piping networK. The design is made according to the EN 13480 and the welds needs to be checked with 5% RT according to the same norme. The types of defects are classified according to...

Part and Inventory Search

Back
Top