Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Control a surface with a sketch dimension (NX8)
Hi John, Here is a picture of what I was trying to do. What crowski suggested worked fine. Very simple problem that I could not figure out. I usually use motion and arrangements but this particular file is for a colleague that does not use NX much. If there are additional ways of doing the...- zeipe
- Post #5
- Forum: Siemens: UG/NX
-
Control a surface with a sketch dimension (NX8)
Thank you very much !!- zeipe
- Post #3
- Forum: Siemens: UG/NX
-
Control a surface with a sketch dimension (NX8)
Haven't used sketcher much in UG at all and have a question. I have a surface that was created outside of sketcher and I want it to rotate when I change an angle dimension in a sketch. Is this possible in NX8? Thanks in advance for your help !!!- zeipe
- Thread
- Replies: 5
- Forum: Siemens: UG/NX
