@IRstuff That's what I thought too. The software will allow me to put a dead zone in and that may deal with the cross axis as you put it. I only get 20 to 30 ohms difference so I guess I have to just try it and see.
Menessis
Some one on another forum has worked out the electronics to wire a pair of FSR's together to act like a trim pot. By doing it that way it just plugs back into our boards too. And there is an op amp involved as well as trim pots and then last but not least software that we can fine tune it...
Member only forum....didn't see that one coming.
OK this is what I have so far. The tubes on top are the eight spacers that the bolts pass through to hold it in place. The tubes on the bottom are not part of the project. The FSR's will be in 4 locations. Top, bottom, left and right between...
Need some help getting my head around what I need to build to make this work. If you look at the links I have listed here you can see a drawing of what it is that I am talking about. I want to put a FSR at the 4 cardinal positions in this joystick. I would like it to be bolted up tight so...
