Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: seayaker
  • Content: Threads
  • Order by date
  1. seayaker

    flame sensor

    I need to make this flame sensor open the solenoid which lets the gas flow to the burner, so If the flame goes out the gas will shut off. If I connect a 3v battery to the solenoid it will open and the gas will flow, my meter says it draws 0.22 amps, The flame sensor puts out a very slight signal...
  2. seayaker

    DIY radiant heat system

    I'm exploring the possibility of making a radiant floor heating system for a RV or van with a propane tankless water heater. I've been using a 12 liter per min. heater in a RV for years and am very happy with it. I just wonder how efficient it would be if I got a water pump and some pex tubing...
  3. seayaker

    voltage regulator

    anyone know a of a good voltage regulator circuit for a prototype generator? the output will be between 5-30 amps and 10-40v but could go up to 60v depending on rpm. Is it possible to start with a buck-boost ic and add transistors to handle the current? efficiency is the priority, any advice...
  4. seayaker

    scr/triac commutation

    I built a single phase permanent magnet generator that needs to be commutated. It will operate at between 10-50v and 5-40 amps. I am starting from scratch as far as electrical commutation so please bare with me. I realize this could be more complicated then it appears but if anyone could steer...

Part and Inventory Search

Back
Top