Does anyone know where I can get low temperature properties, stress-strain curve, yield strength, modulus, for unfilled PPO+PS and 15% glass reinforced PP. I'm looking for properties at -20 degrees C.
I am interested in finding out if the field is moving away from using a general, or boiler-plate tolerance block on a drawing format or if most organizations are continuing to use it. Any opinions would be appreciated.
Does anyone know of a solvent that will remove a medallion from a porcelain finish without damaging the surface? The medallion is fixed to the surface using an automotive trim type adhesive.
This is a salvage need so quantities are low.
Has anybody had any experience with the use of regrind in molding Nylind 51 HSL glass fiber reinforced nylon. Specifically, I am looking for a percentage of regrind that can be used without shorting the glass fiber length.
Other than cold cavity surface (less than 150 degrees F), what kind of molding conditions would contribute to the lack of a resin-rich surface of a gear molded out of Celcon GC25A?
I need to check the profile of the tooth surface of a 52 tooth, 17 NDP, 20 degree PA molded plastic gear. Does anyone know of templates which may be available to use on an optical comparator or, perhaps, of a better way to measure the gear tooth profile?
I remember when Y14.5 Standard for Dimensioning and Tolerancing first was introduced, the term applied for the tolerance of a hole location defined by basic dimensions was "True Position". Later, the term was changed and became "Position". Does anyone know if it has been changed back to "True...
I am looking for anyone having a bad experience due to changing from 301 to 201 stainless in thicknesses in the .035 to .045 range, specifically due to a cycling load.
I have an application in which I will be gluing a friction material to mild steel which needs to have a corosion resistant coating. Currently, the coating is zinc phosphate but I can switch to zinc di-chromate if need be. The adhesive is phenolic based and is baked at 400 degrees F.
My...
I am trying to create a radial pattern to form five spokes in a wheel. When I use (2) as the number of instances it works well but if I try to change it to (5) it fails. Am I having a problem with this build of Wildfire 2.0.
I'm sure the section I am trying to cut will fit in a 72 degree segment.
Is there still some method of creating a cross section in part mode? I can't find anything among the maddening array of meaningless icons or picks and when I go to search help it just leads me down a bunch of dead-end paths.
I'm having great difficulty with Wildfire 2.0. It almost seems as though I would be better off if I had not been a user since release 5 in the early 90's and continued to build my skills since. I can't even seem to select an edge when I am trying to define sketching references. It just keeps...
