Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: drossfree
  • Content: Threads
  • Order by date
  1. drossfree

    fo3015 160-iL

    i need to know if there is a way to cut without a table inside my machine.
  2. drossfree

    i run an Amada FO3015 with160il con

    i run an Amada FO3015 with160il control i just changed cooling water and cannot remember how to reset the active timer any help would be appreciated.
  3. drossfree

    Perforated sheet

    I have a job coming up that requires 11,000 slots to be cut in 1 sheet the way it is programmed at the moment is in 4 separate programs as the programs are too large for my machine memory. I'm running an amada fo3015 4KW with 160-il controller. Is there a way for me to make a macro or subprogram...
  4. drossfree

    Fo3015 with 160i-L control

    I have a job which requires me to cut 300 sheets of the same program I added a table change to the start of the program so I only need to hit start after the program ends to start cutting next sheet. My question is : how do I get the program to restart without pressing start
  5. drossfree

    reappearing rust on stainless.

    After passivating our 316l base mtl and 316l filler wire welds we have roccuring rust spots appearing on occaisonal joints how can we check to ensure that these spots will not reoccur without waiting a week. how long would it take for rust spots to reappear after applying a saline solution. or...
  6. drossfree

    need cut conditions for mild steel

    could somebody send me cut conditions for mild steel we generally cut ss and my cut conditions are fine but mld steel cuts very bad with existing conditions. machine type is Amada FO3015 with 4kw resonator. any help would be greatly appreciated.
  7. drossfree

    pierce parameters amada fo3015 fanuc ctrl

    could someone help me with a soft pierce for 5/8 hrs. I am cutting 3/8 holes in 5/8 hrs edge quality is good but my pierce is gouging material outside the cut line. I know it can be done because I used to cut 1/8 holes in 1/2 material on a trumpf L3030

Part and Inventory Search