Hello,
I hope I am phrasing this question clearly.
I am looking to transition into the hydrogen industry, and one of the big players currently are fuel cell companies.
I am curious as to what process engineers actually do in these organisations. Assuming a company manufactures a container...
Hello guys
First of all I apologise if this has been covered somewhere else, I have done a bit of searching but haven't seen it.
As the topic suggests, what I have is a closed loop heat transfer system which heats up process streams around an oil & gas separation facility. The HTF (Therminol...
Hi guys
I had posted this topic in another thread, but was advised to post over here instead.
Basically I'm involved in a project for a fuel storage facility.
We are designing tanks both fixed roof tanks, and internal floating decks, and I am sizing vents for these tanks.
The requirements...
Hi.
I'm involved in a project for a fuel storage facility.
We are designing tanks both fixed roof tanks, and internal floating decks, and I am sizing vents for these tanks.
The requirements and calculations for fixed roof tanks are quite detailed in API 2000, however it explicitly states...
Hi.
I am trying to size a pump for a client, to output chemicals from an injection pot to an overhead tank. The capacity of the pump they want is in the 10gallon per hour range (the chemical injection shot pot is 2 gallons in volume). However, I am getting very small values for suction size...
Hi.
I am currently involved in a design involving a vessel which is to drain by gravity. I am trying to calculate the maximum velocity of flow [at maximum fluid height in tank]. Now i have seen a lot of papers and even answered posts on here about solving for discharge time through an orifice...
Hi. I am doing some work on crude oil separation and am having problems finding correlations / methods on pressure drop calculations for the crude lines. Basically it's a design for a new flowstation, and i am trying to do some preliminary line sizing calculations.
Is it OK to assume a...
I'm a [junior] process engineer, learning how to use HYSYS. The tutorials that came with the software have been helpful, however, when i finished modelling the ACID-gas sweetening with DEA tutorial, there was an excercise which basically asked me to make changes to the model to accept a doubling...
